1967-72 f100 parting out

[71mishmash]

Hi,
Just wondering if you might have a fan shroud for a 71 super cool rad?
Thanks

[Grandpas72]

Interested in driver and passenger fenders .price on 1972.

[colnago]

I'm looking for a front driveshaft, approx. 33-1/2" from center of u-joint to the splined end.

Joseph

[59yblockf100]

dont have a front drive shaft,all are 2wd,will have to check on condition of front fenders,no shroud,

[colnago]

Not the shaft for a 4x4. I think they're called coupling shafts. It's the short shaft from the tranny output shaft/yoke to the carrier bearing. I'm changing trannies on my 2WD, so I need a new coupling shaft.

Joseph

[59yblockf100]

busy right now now,next weekend i can see if i have the right size,i have a few,

[rbmgf7]

Looking for a spindle assembly. 2WD with drums. Would be nice if I could get at least the hub and drum backing plate.

[pchelp101]

Sent you a PM

[urchinhead]

I am looking for a good '70 grille shell and an original Carlite windshield; do you have any of these parts?

[darren121671]

Im looking for a heater control valve cable. Its app 36-3/4 long.

[stonebystone]

If you're still selling parts, I'm looking for the power steering column bracket that bolts to the outside firewall. I'm converting my '67 to Saginaw power steering. Thanks!

[59yblockf100]

i only have manual steering brackets

[ian1967]

I was wondering if you had some parts available, 1967 F100
Grill, grill upper panel, front bumper, radiator support, driver side fender, and hood latch rod.
thanks

[ian1967]

wondering if you have driver side fender and lower fender cap, radiator support, driver light bezel? thanks

[elvis67]

hi Im looking for small block perch part betwen crossmenber and engine support 302 351 winsor thank you